Help Machining Question
#12
Tom,
Using an R-8 collet to hold the 3/8" shank 1/4" & 5/16" end mills. No, hadn't thought to check the T.I.R. of the end mill. I will do that next time I'm in the shop. I have a .0005 grad. dial indicator that should do the trick. Thanks for the idea. What did my Mom used to say? "2 heads are better than one, even if one's a cabbage head" She said some other stuff, but probably can't post it here. 

Happy Mother's Day to all.
Don
Reply
Thanks given by:


Messages In This Thread
Machining Question - by Don - 05-04-2020, 03:41 PM
RE: Machining Question - by f350ca - 05-04-2020, 05:19 PM
RE: Machining Question - by TomG - 05-04-2020, 06:31 PM
RE: Machining Question - by EdK - 05-04-2020, 09:39 PM
RE: Machining Question - by Highpower - 05-05-2020, 12:48 PM
RE: Machining Question - by Vinny - 05-05-2020, 08:37 PM
RE: Machining Question - by Don - 05-09-2020, 11:56 AM
RE: Machining Question - by Highpower - 05-10-2020, 11:28 AM
RE: Machining Question - by Don - 05-09-2020, 01:15 PM
RE: Machining Question - by EdK - 05-09-2020, 03:47 PM
RE: Machining Question - by TomG - 05-09-2020, 11:21 PM
RE: Machining Question - by Don - 05-10-2020, 01:34 PM
RE: Machining Question - by Don - 05-10-2020, 11:48 PM
RE: Machining Question - by Highpower - 05-11-2020, 07:59 PM
RE: Machining Question - by awemawson - 05-11-2020, 02:00 AM
RE: Machining Question - by Don - 05-11-2020, 10:48 AM
RE: Machining Question - by Don - 05-12-2020, 12:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 02:11 PM
RE: Machining Question - by Don - 05-12-2020, 04:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 08:16 PM



Users browsing this thread: 2 Guest(s)