Help Machining Question
#8
                              
 All right Guys, 
Hopefully I have the attachment(s) attached? What your seeing, I hope is the right hand 1" X 1 1/2" block of alum. clamps in my 3" vise. The triangle piece added to the left hand alum. pc. with the 1" sq. tube at the bottom is the "brace" I added to steady the case when it's dropped through the hole and clamped by the 1/4" stud with the nut positioned horizontally at the extreme left of the fixture. I also added (2) 3/8" pins in addition to the bolts that hold the blocks of alum. together. Necessary in order to achieve correct height of the fixture to clear the almost 6" long case. If this promotes any further ideas and your not giggling to hard at my PA redneck engineering, I'd appreciate any additional thoughts. 
By the way, Ed. My Son (whose project this is) and I were suppose to go to Big Sandy, AZ for the machine gun shoot in Sept., but got rained out. He's been there at least twice before. 
Thanks gentlemen,
Don
Reply
Thanks given by:


Messages In This Thread
Machining Question - by Don - 05-04-2020, 03:41 PM
RE: Machining Question - by f350ca - 05-04-2020, 05:19 PM
RE: Machining Question - by TomG - 05-04-2020, 06:31 PM
RE: Machining Question - by EdK - 05-04-2020, 09:39 PM
RE: Machining Question - by Highpower - 05-05-2020, 12:48 PM
RE: Machining Question - by Vinny - 05-05-2020, 08:37 PM
RE: Machining Question - by Don - 05-09-2020, 11:56 AM
RE: Machining Question - by Highpower - 05-10-2020, 11:28 AM
RE: Machining Question - by Don - 05-09-2020, 01:15 PM
RE: Machining Question - by EdK - 05-09-2020, 03:47 PM
RE: Machining Question - by TomG - 05-09-2020, 11:21 PM
RE: Machining Question - by Don - 05-10-2020, 01:34 PM
RE: Machining Question - by Don - 05-10-2020, 11:48 PM
RE: Machining Question - by Highpower - 05-11-2020, 07:59 PM
RE: Machining Question - by awemawson - 05-11-2020, 02:00 AM
RE: Machining Question - by Don - 05-11-2020, 10:48 AM
RE: Machining Question - by Don - 05-12-2020, 12:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 02:11 PM
RE: Machining Question - by Don - 05-12-2020, 04:35 PM
RE: Machining Question - by Highpower - 05-12-2020, 08:16 PM



Users browsing this thread: 2 Guest(s)