Problem with lead screw/half nut/s
#4
(08-09-2019, 02:13 PM)TomG Wrote: What kind of lathe? Does this deflection occur everywhere along the leadscrew, or just near one end?

Tom

Chinese 8 x 16...….MX210-V if that's any help, deflection occurs everywhere along the lead screw.
Finish is better at the chuck than at the tailstock though.

Cheers.

Roy.
Light travels faster than sound!
This is why some people appear bright until they open their mouth!
Preserve nature...…….Pickle a squirrel! 
Reply
Thanks given by:


Messages In This Thread
RE: Problem with lead screw/half nut/s - by TomG - 08-09-2019, 02:13 PM
RE: Problem with lead screw/half nut/s - by Swarf_Newbie - 08-09-2019, 04:32 PM
RE: Problem with lead screw/half nut/s - by EdK - 08-09-2019, 07:50 PM
RE: Problem with lead screw/half nut/s - by Vinny - 08-09-2019, 11:32 PM
RE: Problem with lead screw/half nut/s - by TomG - 08-10-2019, 08:03 PM



Users browsing this thread: 2 Guest(s)