07-23-2018, 07:53 AM
If you have access to a sandblaster use it as the first step. It will help blend the surfaces before final polishing.
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
How to center a piece of work on a rotary table?
How to center a piece of work on a rotary table?
|
How to center a piece of work on a rotary table?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to center a piece of work on a rotary table? - by ScrapMetal - 06-27-2018, 04:38 PM
RE: How to center a piece of work on a rotary table? - by Dr Stan - 06-28-2018, 07:34 AM
RE: How to center a piece of work on a rotary table? - by Hawkeye - 06-28-2018, 10:24 PM
RE: How to center a piece of work on a rotary table? - by ScrapMetal - 06-30-2018, 03:24 AM
RE: How to center a piece of work on a rotary table? - by ScrapMetal - 06-30-2018, 07:06 PM
RE: How to center a piece of work on a rotary table? - by Hawkeye - 06-30-2018, 10:50 PM
RE: How to center a piece of work on a rotary table? - by ScrapMetal - 07-02-2018, 11:31 PM
RE: How to center a piece of work on a rotary table? - by ScrapMetal - 07-22-2018, 07:00 PM
RE: How to center a piece of work on a rotary table? - by Dr Stan - 07-23-2018, 07:53 AM
RE: How to center a piece of work on a rotary table? - by ScrapMetal - 07-23-2018, 08:04 PM
|
Users browsing this thread: 1 Guest(s)