Herless (rebranded Ta Fu Yuan) TFY-618 Surface Grinder
#12
(02-22-2018, 11:36 AM)Vinny Wrote: This page has a lot of useful info on surface grinders, and grinders/grinding in general.  Unfortunately all it says about the dresser is "slight angle".  As I recall, when I made mine, somewhere I found the number 5 degrees so that's what I went with.

http://www.americanmachinetools.com/how_...rinder.htm

Great info there Vinny.

Figure 5.14 has a good diagram and states "Slant the diamond 3° to 15° in the direction of rotation and 30° to the plane of the wheel as shown in Figure 5-14 to prevent chatter and gouging."

There's other good dressing info in that section too.

Steve
Reply
Thanks given by:


Messages In This Thread
RE: Herless (rebranded Ta Fu Yuan) TFY-618 Surface Grinder - by SteveG - 02-22-2018, 05:02 PM



Users browsing this thread: 2 Guest(s)