MetalworkingFun Forum › Machining › General Metalworking Discussion v
Mill/Drill Way Guards

Thread Modes
Mill/Drill Way Guards
Hawkeye Offline
Junior
****
Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#4
06-26-2017, 10:47 PM
The problem with a lot of eBay listings is that they don't say what machine a drive will fit. When mine had arrived, I could see that it wasn't for my machine. If I mounted the drive at the end of the table, I would lose about 7" of travel. No sweat. I have a machine shop.

The story is found at: http://www.metalworkingfun.com/showthread.php?tid=3446
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Mill/Drill Way Guards - by Hawkeye - 06-25-2017, 11:02 PM
RE: Mill/Drill Way Guards - by Mike E. - 06-26-2017, 04:22 AM
RE: Mill/Drill Way Guards - by stevec - 06-26-2017, 06:37 AM
RE: Mill/Drill Way Guards - by Hawkeye - 06-26-2017, 10:47 PM
RE: Mill/Drill Way Guards - by Hawkeye - 06-26-2017, 10:54 PM
RE: Mill/Drill Way Guards - by Pete O - 06-27-2017, 12:08 AM
RE: Mill/Drill Way Guards - by misterfxt - 06-27-2017, 01:35 PM
RE: Mill/Drill Way Guards - by the penguin - 06-28-2017, 04:26 PM
RE: Mill/Drill Way Guards - by Roadracer_Al - 06-30-2017, 12:54 PM



Users browsing this thread: 1 Guest(s)