MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Having trouble with this

Thread Modes
Having trouble with this
rleete Offline
Junior
****
Posts: 691
Threads: 42
Joined: Mar 2012
Location: Rochester, NY
#5
03-08-2017, 08:21 AM
Chances are, the shaft is just a little too long, and is bottoming out on the chuck before it seats. You may have to grind some off the end of the shaft to get it to work.
Full of ideas, but slow to produce parts
Reply
Thanks given by:


Messages In This Thread
Having trouble with this - by Thumb - 03-07-2017, 11:32 PM
RE: Having trouble with this - by Dr Stan - 03-08-2017, 12:08 AM
RE: Having trouble with this - by Thumb - 03-08-2017, 12:48 AM
RE: Having trouble with this - by Mayhem - 03-08-2017, 07:22 AM
RE: Having trouble with this - by rleete - 03-08-2017, 08:21 AM
RE: Having trouble with this - by pepi - 03-08-2017, 08:39 AM
RE: Having trouble with this - by dallen - 03-08-2017, 09:12 AM
RE: Having trouble with this - by Thumb - 03-08-2017, 10:20 AM



Users browsing this thread: 1 Guest(s)