Surface plate in a roll around tool box
#4
(05-05-2016, 07:53 AM)pepi Wrote: Good idea, having that mobil, speaking of assembly, stands or storage try lock-tight on the fasteners. My experience over the years has lead me to this conclusion. BBQs too tool stands, these type of things are always in motion so to speak, the lock-tight keeps things shored up.

No I would not suggest taking it down to add lock-tight on the fasteners, just food for thought..

pepi, the nuts sent with this tool cart are the ones with a nylon locking insert.  I doubt they will ever get loose during my low mile per hour application.

I was pleasantly surprised by the quality of the fasteners and the paint job.  The nuts and bolts were the right size and the right quantity.  They are a bright zinc finish so it should be quite a while before they get rusty.

The cart came well packaged and only 2 or 3 little spots that show any rubbing of the paint.  I could easily touch up these small spots with a bottle of model paint and a little brush.
JScott, proud to be a member of MetalworkingFun Forum since Mar 2014.
Reply
Thanks given by:


Messages In This Thread
RE: Surface plate in a roll around tool box - by JScott - 05-05-2016, 08:37 AM



Users browsing this thread: 1 Guest(s)