|
Walter Tool Catalogue
|
06-17-2016, 09:16 AM
(06-17-2016, 05:41 AM)ronboult Wrote: But how do I hold the tailstock end? The slot in the R8 shank for the spindle locating pin rules out a fixed steady. Turn a short threaded arbor that screws into the R-8 end and put a center in the end of the arbor? 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Walter Tool Catalogue - by ronboult - 04-28-2016, 11:28 PM
RE: Walter Tool Catalogue - by Dr Stan - 04-28-2016, 11:31 PM
RE: Walter Tool Catalogue - by ronboult - 04-28-2016, 11:55 PM
RE: Walter Tool Catalogue - by Mayhem - 04-29-2016, 05:40 AM
RE: Walter Tool Catalogue - by ronboult - 04-29-2016, 06:24 AM
RE: Walter Tool Catalogue - by Mayhem - 04-29-2016, 07:22 AM
RE: Walter Tool Catalogue - by PixMan - 04-29-2016, 08:22 AM
RE: Walter Tool Catalogue - by ronboult - 04-30-2016, 04:50 AM
RE: Walter Tool Catalogue - by Mayhem - 04-30-2016, 08:06 AM
RE: Walter Tool Catalogue - by PixMan - 05-26-2016, 07:44 PM
RE: Walter Tool Catalogue - by ronboult - 05-29-2016, 05:18 AM
RE: Walter Tool Catalogue - by PixMan - 05-30-2016, 08:21 PM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 05:41 AM
RE: Walter Tool Catalogue - by Highpower - 06-17-2016, 09:16 AM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 05:51 AM
RE: Walter Tool Catalogue - by PixMan - 06-17-2016, 04:25 PM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 05:56 PM
RE: Walter Tool Catalogue - by Highpower - 06-17-2016, 08:15 PM
RE: Walter Tool Catalogue - by Vinny - 06-17-2016, 06:13 PM
RE: Walter Tool Catalogue - by Mayhem - 06-17-2016, 08:16 PM
RE: Walter Tool Catalogue - by ronboult - 06-17-2016, 08:29 PM
|
