Band saw blades question
#14
Likely the cutting speed. I test and adjust as I go. It seems that I do not have options beside buying from Proxxon. Did some searching on the web but didn't find the same measurements shown on the box of the new blade from Proxxon.

I bought the stick wax from ptreeusa.com. It helps to keep the noise down. Maybe I'm pushing it a little too hard. I'll experiment somemore.

Regards,
Wong
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
Band saw blades question - by pjf134 - 04-11-2012, 10:58 PM
RE: Band saw blades question - by aametalmaster - 04-11-2012, 11:32 PM
RE: Band saw blades question - by starlight_tools - 04-12-2012, 12:02 AM
RE: Band saw blades question - by aametalmaster - 04-12-2012, 05:02 PM
RE: Band saw blades question - by Bogstandard - 04-12-2012, 02:25 AM
RE: Band saw blades question - by EdK - 04-12-2012, 05:51 AM
RE: Band saw blades question - by Highpower - 04-12-2012, 07:32 AM
RE: Band saw blades question - by DaveH - 04-12-2012, 07:55 AM
RE: Band saw blades question - by stevec - 04-12-2012, 08:51 AM
RE: Band saw blades question - by ETC57 - 04-12-2012, 01:35 PM
RE: Band saw blades question - by Wongster - 04-18-2012, 01:39 AM
RE: Band saw blades question - by DaveH - 04-18-2012, 06:08 AM
RE: Band saw blades question - by starlight_tools - 04-18-2012, 10:33 AM
RE: Band saw blades question - by EdK - 04-18-2012, 06:26 AM
RE: Band saw blades question - by Wongster - 04-18-2012, 07:35 AM
RE: Band saw blades question - by EdK - 04-18-2012, 04:05 PM
RE: Band saw blades question - by stevec - 04-18-2012, 06:59 PM
RE: Band saw blades question - by Bogstandard - 04-18-2012, 07:05 PM
RE: Band saw blades question - by Wongster - 04-18-2012, 07:52 PM
RE: Band saw blades question - by Bogstandard - 04-19-2012, 12:30 AM
RE: Band saw blades question - by Wongster - 04-19-2012, 01:33 AM
RE: Band saw blades question - by PixMan - 05-17-2012, 08:26 PM



Users browsing this thread: 1 Guest(s)