Lets see your die filing machine
#11
I think Victor tools has them, but I've made them, or repurposed I should say. Grind the end of the file down to fit inside a 3/16 hole , drill a 3/16 hole in a 5/16 shaft and epoxy it in. Then chuck the file and turn down the shaft to 1/4. This sets the shank in line with the file. Rob's might have a bigger clamp arrangement though.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: EdK


Messages In This Thread
Lets see your die filing machine - by RobWilson - 03-11-2015, 08:07 AM
RE: Lets see your die filing machine - by Mayhem - 03-11-2015, 08:22 AM
RE: Lets see your die filing machine - by EdK - 03-11-2015, 04:37 PM
RE: Lets see your die filing machine - by f350ca - 03-11-2015, 05:20 PM
RE: Lets see your die filing machine - by Hawkeye - 03-11-2015, 09:04 PM
RE: Lets see your die filing machine - by RobWilson - 03-12-2015, 02:30 AM
RE: Lets see your die filing machine - by rleete - 03-12-2015, 11:55 AM
RE: Lets see your die filing machine - by EdK - 03-12-2015, 05:05 PM
RE: Lets see your die filing machine - by f350ca - 03-12-2015, 05:14 PM
RE: Lets see your die filing machine - by Hawkeye - 03-12-2015, 09:14 PM
RE: Lets see your die filing machine - by RobWilson - 03-13-2015, 03:43 PM
RE: Lets see your die filing machine - by DaveH - 03-13-2015, 04:10 PM
RE: Lets see your die filing machine - by EdK - 03-13-2015, 04:12 PM
RE: Lets see your die filing machine - by dallen - 03-16-2015, 07:17 PM
RE: Lets see your die filing machine - by dallen - 03-16-2015, 10:37 PM
RE: Lets see your die filing machine - by Scruffy - 08-26-2015, 03:43 PM
RE: Lets see your die filing machine - by EdK - 08-26-2015, 05:46 PM
RE: Lets see your die filing machine - by RobWilson - 03-09-2016, 03:20 PM
RE: Lets see your die filing machine - by DaveH - 03-09-2016, 04:17 PM
RE: Lets see your die filing machine - by RobWilson - 03-09-2016, 04:36 PM



Users browsing this thread: 2 Guest(s)