MetalworkingFun Forum › Machining › General Metalworking Discussion v
Between centers boring bar

Thread Modes
Between centers boring bar
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#8
11-06-2014, 10:34 AM
I agree with Greg if the cutter is mounted in the bar between centers and the part on the carriage the runout that you have doesn't matter, because the cutter is stationary in one spot between the centers

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Between centers boring bar - by chucketn - 11-06-2014, 09:23 AM
RE: Between centers boring bar - by JScott - 11-06-2014, 09:38 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 09:48 AM
RE: Between centers boring bar - by f350ca - 11-06-2014, 09:59 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 10:09 AM
RE: Between centers boring bar - by f350ca - 11-06-2014, 10:27 AM
RE: Between centers boring bar - by Lordedmond - 11-06-2014, 10:31 AM
RE: Between centers boring bar - by dallen - 11-06-2014, 10:34 AM
RE: Between centers boring bar - by EdK - 11-06-2014, 11:04 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 11:54 AM
RE: Between centers boring bar - by TomG - 11-06-2014, 12:51 PM
RE: Between centers boring bar - by chucketn - 11-06-2014, 01:10 PM
RE: Between centers boring bar - by TomG - 11-06-2014, 02:44 PM
RE: Between centers boring bar - by doubleboost - 11-06-2014, 01:07 PM
RE: Between centers boring bar - by Lordedmond - 11-06-2014, 01:21 PM
RE: Between centers boring bar - by Dr Stan - 11-06-2014, 10:19 PM
RE: Between centers boring bar - by chucketn - 11-07-2014, 06:49 AM
RE: Between centers boring bar - by stevec - 11-07-2014, 07:33 AM
RE: Between centers boring bar - by Dr Stan - 11-07-2014, 12:42 PM
RE: Between centers boring bar - by doubleboost - 11-07-2014, 12:45 PM
RE: Between centers boring bar - by chucketn - 11-07-2014, 05:19 PM
RE: Between centers boring bar - by Hopefuldave - 11-09-2014, 08:17 AM



Users browsing this thread: 1 Guest(s)