12-05-2013, 12:28 AM
Moving day. The seller called just after 11:00. Took an hour twenty to load up and drop the lathe in my garage.
The journey begins. My side driveway is a type of gravel that breaks through with no warning, so I'm using a couple of sheets of plywood to build a road.
Halfway there.
The 2x4 across the dolly allows it to pivot over any small obstacles.
Around the last corner.
Waiting at the door.
Not much room to slide through. Big Victoria mill on the other side.
The lathe is in place at 5:00 sharp.
Just have to run the power and she'll be running.
The journey begins. My side driveway is a type of gravel that breaks through with no warning, so I'm using a couple of sheets of plywood to build a road.
Halfway there.
The 2x4 across the dolly allows it to pivot over any small obstacles.
Around the last corner.
Waiting at the door.
Not much room to slide through. Big Victoria mill on the other side.
The lathe is in place at 5:00 sharp.
Just have to run the power and she'll be running.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.