Cleaning up an old milling machine
#11
(09-17-2012, 10:53 PM)PixMan Wrote: Wow, that machine looks GOOD! It's a very heavy duty one with a 3HP spindle and 10x50 table if my guess is right.

So where are you located anyhow? I've never seen one that looks like that, with the Y-axis screw off-center like that. What brand is it?

I am located in Sacramento Ca. The machine is deceiving, the spec sheet said it came with a 1hp or 2hp motor, actually what is has is 1/2hp and it uses r8 tooling. Table is 44" x 10" table with 22" of travel. Machine was made by Balding Engineering in England and is their small "training or light duty machine" named a PAL. Big brother was the Beaver VBRP.
ml_woy, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Cleaning up an old milling machine - by ml_woy - 09-17-2012, 11:06 AM
RE: Cleaning up an old milling machine - by truckin23 - 09-17-2012, 07:52 PM
RE: Cleaning up an old milling machine - by ml_woy - 09-18-2012, 09:39 AM
RE: Cleaning up an old milling machine - by EdK - 09-18-2012, 05:29 AM
RE: Cleaning up an old milling machine - by DaveH - 09-18-2012, 01:14 PM
RE: Cleaning up an old milling machine - by truckin23 - 09-18-2012, 09:14 PM
RE: Cleaning up an old milling machine - by DaveH - 09-27-2012, 01:16 PM
RE: Cleaning up an old milling machine - by DaveH - 12-31-2012, 11:56 AM



Users browsing this thread: 2 Guest(s)