06-06-2016, 11:58 PM
Well I'm glad you all insisted...
I used the arbor to centre the nut in the 4-jaw, then left the arbor in place to steady the nut
A spinoff project was to mill my MTGNR 32x32 carbide insert holder to fit in a QCTP toolholder.
Chamfered the nut at 45 degrees.
Hope you're all happier now .
I used the arbor to centre the nut in the 4-jaw, then left the arbor in place to steady the nut
A spinoff project was to mill my MTGNR 32x32 carbide insert holder to fit in a QCTP toolholder.
Chamfered the nut at 45 degrees.
Hope you're all happier now .
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components.
Milling Machine (n); a machine tool used in the production of lathe components.