ER40 - How Thin?

Thread Modes

ER40 - How Thin?

Vinny

Another Whipping Boy

Posts: 2,597
Threads: 99
Joined: Dec 2014
Location: Michigan

The following 4 users Like Vinny's post:
JScott (02-16-2023), f350ca (02-16-2023), Highpower (02-16-2023), EdK (02-16-2023)

#12

02-16-2023, 04:10 PM

Here are the first batch of coin blanks. The pot style chuck worked out fine although I had some issues cutting the slots. Main problem was the crappy hacksaw didn't hold the blade straight and kept going off on an angle, then I switched to the multitool and that did a nice straight cut, till the blade gave out and I couldn't find my spares (eventually found them - where they belong), I then ended up using a sawsall. Not posting a pic of the chuck - it's UGLY!

[Image: coins-1.jpg]

I'll post some pics of an engraved coin when I do one.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

ER40 - How Thin? - by Vinny - 02-06-2023, 01:31 PM

RE: ER40 - How Thin? - by EdK - 02-06-2023, 10:24 PM

RE: ER40 - How Thin? - by Vinny - 02-06-2023, 11:46 PM

RE: ER40 - How Thin? - by Dr Stan - 02-07-2023, 11:18 AM

RE: ER40 - How Thin? - by Highpower - 02-07-2023, 11:45 AM

RE: ER40 - How Thin? - by Vinny - 02-07-2023, 11:59 AM

RE: ER40 - How Thin? - by EdK - 02-07-2023, 02:38 PM

RE: ER40 - How Thin? - by Highpower - 02-07-2023, 08:33 PM