Strange Brackets

Thread Modes

Strange Brackets

EdK

Whipping Boy

Posts: 8,742
Threads: 313
Joined: Feb 2012
Location: Arizona/Minnesota

The following 2 users Like EdK's post:
Highpower (03-22-2023), Vinny (03-22-2023)

#31

03-22-2023, 10:07 AM

(03-22-2023, 04:38 AM)Highpower Wrote: I just faced the ends of a few pieces of bar stock (different lengths) using the DRO and then measured them with micrometers. They all measured within .0006" of what the DRO (.0002" resolution) showed without any correction. I left it alone. Good enough for my neighborhood.

Now that I can understand. I think I'll just go ahead and machine the t-slot nuts using the DRO and take measurements after to see if it matches the print.

Ed

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Strange Brackets - by EdK - 01-02-2023, 12:07 PM

RE: Strange Brackets - by Highpower - 01-02-2023, 12:22 PM

RE: Strange Brackets - by EdK - 01-02-2023, 12:25 PM

RE: Strange Brackets - by Highpower - 01-02-2023, 12:31 PM

RE: Strange Brackets - by EdK - 01-02-2023, 12:36 PM

RE: Strange Brackets - by EdK - 01-05-2023, 11:32 PM

RE: Strange Brackets - by Dr Stan - 01-06-2023, 07:41 AM

RE: Strange Brackets - by EdK - 01-07-2023, 11:38 AM

RE: Strange Brackets - by Highpower - 01-07-2023, 02:54 PM