07-14-2021, 09:07 PM
I installed it on the drill press and measured the run-out at slightly more than .003" using a .3125" gauge pin. I can live with that. It's much better than the chuck that came with the drill press.
Ed
Ed
|
Rohm Drill Chuck
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rohm Drill Chuck - by EdK - 07-13-2021, 11:47 PM
RE: Rohm Drill Chuck - by EdK - 07-14-2021, 01:42 PM
RE: Rohm Drill Chuck - by Highpower - 07-14-2021, 02:22 PM
RE: Rohm Drill Chuck - by EdK - 07-14-2021, 03:44 PM
RE: Rohm Drill Chuck - by Highpower - 07-14-2021, 09:02 PM
RE: Rohm Drill Chuck - by EdK - 07-14-2021, 09:07 PM
RE: Rohm Drill Chuck - by EdK - 08-10-2021, 03:02 PM
|
Users browsing this thread: 1 Guest(s)