MetalworkingFun Forum › Machining › General Shop Stuff v
Thermostat help

Thread Modes
Thermostat help
Dr Stan Offline
Senior
*****
Posts: 2,324
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#5
12-06-2019, 10:36 PM
(12-06-2019, 06:09 PM)Pete O Wrote: I'd be testing with different wattage light bulbs, you may well find you get in the temp range you want without any other mods.

The only incandescent light bulb of sufficient wattage I could find was 300 watt.
Reply
Thanks given by:


Messages In This Thread
Thermostat help - by Dr Stan - 12-06-2019, 06:04 PM
RE: Thermostat help - by Pete O - 12-06-2019, 06:09 PM
RE: Thermostat help - by Dr Stan - 12-06-2019, 10:36 PM
RE: Thermostat help - by TomG - 12-06-2019, 07:25 PM
RE: Thermostat help - by f350ca - 12-06-2019, 09:18 PM
RE: Thermostat help - by Dr Stan - 12-06-2019, 10:38 PM
RE: Thermostat help - by Highpower - 12-07-2019, 12:18 AM
RE: Thermostat help - by Highpower - 12-07-2019, 12:04 AM
RE: Thermostat help - by Vinny - 12-07-2019, 09:11 PM



Users browsing this thread: 1 Guest(s)