MetalworkingFun Forum › Machining › General Metalworking Discussion v
What the heck is (was) this?

Thread Modes
What the heck is (was) this?
frankie Offline
Freshman
**
Posts: 1
Threads: 0
Joined: May 2022
Location: USA
The following 4 users Like frankie's post:
EdK (01-26-2023), Highpower (01-27-2023), Vinny (01-27-2023), arvidj (01-27-2023)
#11
01-26-2023, 08:45 PM
Terry is correct it is a platen for rubber molding press. I worked as a machinist/mold maker for 42 years. I also notice that Terry is from Jordan MN. We may have worked at the same companies.
Frankie
Reply
Thanks given by:


Messages In This Thread
What the heck is (was) this? - by Pete O - 08-29-2018, 04:27 AM
RE: What the heck is (was) this? - by f350ca - 08-29-2018, 08:58 AM
RE: What the heck is (was) this? - by Pete O - 08-29-2018, 07:17 PM
RE: What the heck is (was) this? - by Mike E. - 08-30-2018, 06:40 PM
RE: What the heck is (was) this? - by Pete O - 08-30-2018, 10:05 PM
RE: What the heck is (was) this? - by awemawson - 08-31-2018, 12:54 AM
RE: What the heck is (was) this? - by Pete O - 09-01-2018, 03:42 AM
RE: What the heck is (was) this? - by terrywerm - 09-03-2018, 10:43 PM
RE: What the heck is (was) this? - by Pete O - 09-04-2018, 08:24 PM
RE: What the heck is (was) this? - by Clifford B. - 12-13-2018, 07:10 PM
RE: What the heck is (was) this? - by frankie - 01-26-2023, 08:45 PM



Users browsing this thread: 1 Guest(s)