MetalworkingFun Forum › Machining › General Metalworking Discussion v
How to center a piece of work on a rotary table?

Thread Modes
How to center a piece of work on a rotary table?
ScrapMetal Offline
Junior
****
Posts: 275
Threads: 12
Joined: Mar 2012
Location: Nebraska, USA
#7
07-02-2018, 11:31 PM
That makes sense. I will give it a try as soon as I get/make a tooling plate large enough.

I should have a plate ready to go in a week or so and then I'll post my progress.

Thanks very much guys,

-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
Reply
Thanks given by:


Messages In This Thread
RE: How to center a piece of work on a rotary table? - by ScrapMetal - 07-02-2018, 11:31 PM



Users browsing this thread: 2 Guest(s)