MetalworkingFun Forum › Machining › General Metalworking Discussion v
How to center a piece of work on a rotary table?

Thread Modes
How to center a piece of work on a rotary table?
Dr Stan Offline
Senior
*****
Posts: 2,324
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
The following 1 user Likes Dr Stan's post:
EdK (06-28-2018)
#2
06-28-2018, 07:34 AM
Without seeing the part or a drawing of the same my best guess is to use a tooling plate on top of the RT.  By a tooling plate I mean a piece of material (usually 1" thick aluminum) with equally spaced drilled and tapped and drilled and reamed holes.
Reply
Thanks given by:


Messages In This Thread
RE: How to center a piece of work on a rotary table? - by Dr Stan - 06-28-2018, 07:34 AM



Users browsing this thread: 1 Guest(s)