The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Mill/Drill Way Guards

Thread Modes
Mill/Drill Way Guards
Hawkeye Offline
Junior
****
Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
The following 3 users Like Hawkeye's post:
Mike E. (06-26-2017), EdK (06-26-2017), DaveH (06-26-2017)
#1
06-25-2017, 11:02 PM
About two years ago, I got a new RF-30 mill/drill to replace the 25 that got all rusted up in my house fire. The rubber way guard behind the table already has a couple of holes and a slit that runs almost all the way across.
   

I had been wondering if the belt from a treadmill could be used to replace it. This weekend, I gave it a try. It seems flexible enough to fold up as you move the table back.
   

   

While I was at it, I made a table cover to help with clean-up.
   
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Mill/Drill Way Guards - by Hawkeye - 06-25-2017, 11:02 PM
RE: Mill/Drill Way Guards - by Mike E. - 06-26-2017, 04:22 AM
RE: Mill/Drill Way Guards - by stevec - 06-26-2017, 06:37 AM
RE: Mill/Drill Way Guards - by Hawkeye - 06-26-2017, 10:47 PM
RE: Mill/Drill Way Guards - by Hawkeye - 06-26-2017, 10:54 PM
RE: Mill/Drill Way Guards - by Pete O - 06-27-2017, 12:08 AM
RE: Mill/Drill Way Guards - by misterfxt - 06-27-2017, 01:35 PM
RE: Mill/Drill Way Guards - by the penguin - 06-28-2017, 04:26 PM
RE: Mill/Drill Way Guards - by Roadracer_Al - 06-30-2017, 12:54 PM



Users browsing this thread: 1 Guest(s)