Squaring up a part within .0002" on a knee mill.

Hello There, Guest! Register

Thread Modes

Squaring up a part within .0002" on a knee mill.

Viperspit Offline

Offline

Freshman

Posts: 21
Threads: 9
Joined: Apr 2017
Location: Michigan

The following 2 users Like Viperspit's post:
f350ca (05-14-2017), Pete O (05-14-2017)

#4

05-14-2017, 02:34 PM

Here is part 2 https://www.youtube.com/watch?v=upUYGTwD4Qk

Reply

Thanks given by: EdK

« Next Oldest | Next Newest »

Messages In This Thread

Squaring up a part within .0002" on a knee mill. - by Viperspit - 05-13-2017, 09:15 PM

RE: Squaring up a part within .0002" on a knee mill. - by Mike E. - 05-14-2017, 10:09 AM

RE: Squaring up a part within .0002" on a knee mill. - by Viperspit - 05-14-2017, 11:56 AM

RE: Squaring up a part within .0002" on a knee mill. - by Dr Stan - 05-14-2017, 03:18 PM

RE: Squaring up a part within .0002" on a knee mill. - by Viperspit - 05-14-2017, 02:34 PM

RE: Squaring up a part within .0002" on a knee mill. - by Pete O - 05-14-2017, 05:10 PM

RE: Squaring up a part within .0002" on a knee mill. - by Viperspit - 05-14-2017, 05:45 PM

Users browsing this thread: 1 Guest(s)