Changes To The Franken-Drill Adapter Plate
#2
On to the Mark 4 version, I revamped the plate again, I cut the ears off the back of the plate and rewelded the plate to close up the slots on the back edge. After thinking about the plate, I couldn't think of why I actually cut the notch in the back of the plate, leaving the ears, as long as the table stayed centered, not an issue, but the ears couls cause a limitation on side travel, so they had to go.


Attached Files Thumbnail(s)
       
jack
Reply
Thanks given by:


Messages In This Thread
RE: Changes To The Franken-Drill Adapter Plate - by the penguin - 10-16-2016, 10:46 AM



Users browsing this thread: 1 Guest(s)