06-10-2015, 11:37 AM
(This post was last modified: 06-10-2015, 11:56 AM by Swede56.
Edit Reason: Spelling Error
)
I won the bid on ebay for Albrecht Keyless Chuck 1/8-5/8.
Is there a standard taper for the chuck?
There are some arbors listed for different chucks but I want a ½ to 5/8 straight arbor.
To get an arbor with possible zero run out I may end up making one between centers on my Atlas lathe.
Until I get delivery of the chuck I will not know if it has a arbor for a lathe, an R-8 or a straight arbor it was not in the description.
If the arbor is straight I am good to go if it is not to long.
The reason for a straight arbor is to keep the drill chuck as short as possible.
Please excuse my lack of proper names for the chuck parts in question.
Any information will be helpful.
Is there a standard taper for the chuck?
There are some arbors listed for different chucks but I want a ½ to 5/8 straight arbor.
To get an arbor with possible zero run out I may end up making one between centers on my Atlas lathe.
Until I get delivery of the chuck I will not know if it has a arbor for a lathe, an R-8 or a straight arbor it was not in the description.
If the arbor is straight I am good to go if it is not to long.
The reason for a straight arbor is to keep the drill chuck as short as possible.
Please excuse my lack of proper names for the chuck parts in question.
Any information will be helpful.