The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Surface grinder books ?
#1
I have one of those little 6x12 surface grinders that everyone else has


I bought it out of a school twenty years ago and have never set it up properly

I swapped the three phase motor for a single phase back before vfd's ere popular and cheap, so .75 HP and maybe not as balanced as the original was.




I've mounted a wheel and done some things but none of them come out straight because nothing is set up

I'm sure it's all my lack of knowledge rather than the fault of the machine.


Is there a good book that covers everything from basic setup to wheel selection and setups

I'd love to sharpen endmills and cutters drills and such


I like real paper books, but I love those free pdf's of the old books too so either one suits me fine.
Reply
Thanks given by:


Messages In This Thread
Surface grinder books ? - by 12345678910 - 03-16-2015, 05:36 PM
RE: Surface grinder books ? - by EdK - 03-16-2015, 05:38 PM
RE: Surface grinder books ? - by arvidj - 03-16-2015, 07:22 PM
RE: Surface grinder books ? - by f350ca - 03-16-2015, 07:31 PM
RE: Surface grinder books ? - by Dr Stan - 03-16-2015, 10:31 PM
RE: Surface grinder books ? - by Sunset Machine - 03-17-2015, 07:39 AM
RE: Surface grinder books ? - by Dr Stan - 03-17-2015, 02:16 PM
RE: Surface grinder books ? - by tekfab - 03-17-2015, 10:38 AM



Users browsing this thread: 1 Guest(s)