MetalworkingFun Forum › Machining › General Metalworking Discussion v
Vice advice

Thread Modes
Vice advice
mike-sid Offline
Sophmore
***
Posts: 137
Threads: 16
Joined: Jan 2015
Location: Oxford, CT
#14
03-05-2015, 06:30 AM
(02-17-2015, 05:11 PM)EdK Wrote: Mike,

What mill do you currently have?

Ed


  ED,    My  Frankenmill sports a Bridgeport 1 1/2 hp high speed head, and its base is a Hardnige TM horizontal mill.
Looks like I'm all in with this mill since I just bought the DRO.
[Image: mill049.jpg]
Reply
Thanks given by: EdK


Messages In This Thread
Vice advice - by mike-sid - 02-16-2015, 03:01 PM
RE: Vice advice - by JScott - 02-16-2015, 04:00 PM
RE: Vice advice - by Arbalest - 02-16-2015, 05:28 PM
RE: Vice advice - by mike-sid - 02-16-2015, 08:45 PM
RE: Vice advice - by Mayhem - 02-16-2015, 11:54 PM
RE: Vice advice - by Shawn - 02-17-2015, 12:06 AM
RE: Vice advice - by Mayhem - 02-17-2015, 07:35 AM
RE: Vice advice - by stevec - 02-17-2015, 07:52 AM
RE: Vice advice - by PixMan - 02-17-2015, 08:35 AM
RE: Vice advice - by mike-sid - 02-17-2015, 09:03 AM
RE: Vice advice - by Mayhem - 02-17-2015, 09:07 AM
RE: Vice advice - by EdK - 02-17-2015, 05:11 PM
RE: Vice advice - by mike-sid - 03-05-2015, 06:30 AM
RE: Vice advice - by Dr Stan - 02-17-2015, 09:01 PM
RE: Vice advice - by Mayhem - 03-05-2015, 08:25 AM
RE: Vice advice - by mike-sid - 03-05-2015, 09:19 AM
RE: Vice advice - by Mayhem - 03-05-2015, 09:42 AM
RE: Vice advice - by DaveH - 03-05-2015, 11:49 AM
RE: Vice advice - by arvidj - 03-05-2015, 01:24 PM
RE: Vice advice - by Highpower - 03-05-2015, 04:13 PM
RE: Vice advice - by mike-sid - 03-05-2015, 10:29 AM
RE: Vice advice - by stevec - 03-06-2015, 08:05 AM



Users browsing this thread: 1 Guest(s)