Keyway Bushing
#15
I have one just like that. And people say you can't cut tapered keyways with a broach LOL. I used to borrow my cousins press and all he had was wooden blocks and i didn't notice the pulley sinking in on one side until it was done. Then i finished my press...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Keyway Bushing - by aametalmaster - 04-07-2012, 10:47 AM
RE: Keyway Bushing - by Highpower - 04-07-2012, 10:58 AM
RE: Keyway Bushing - by EdK - 04-07-2012, 11:50 AM
RE: Keyway Bushing - by DaveH - 04-07-2012, 11:55 AM
RE: Keyway Bushing - by Highpower - 04-07-2012, 06:01 PM
RE: Keyway Bushing - by stevec - 04-07-2012, 05:12 PM
RE: Keyway Bushing - by DaveH - 04-07-2012, 06:12 PM
RE: Keyway Bushing - by aametalmaster - 04-07-2012, 06:25 PM
RE: Keyway Bushing - by Highpower - 04-07-2012, 06:42 PM
RE: Keyway Bushing - by PixMan - 04-08-2012, 10:04 AM
RE: Keyway Bushing - by aametalmaster - 04-08-2012, 10:20 AM
RE: Keyway Bushing - by Highpower - 04-08-2012, 05:11 PM
RE: Keyway Bushing - by aametalmaster - 04-08-2012, 07:22 PM
RE: Keyway Bushing - by Highpower - 04-08-2012, 09:34 PM
RE: Keyway Bushing - by aametalmaster - 04-09-2012, 03:44 AM



Users browsing this thread: 1 Guest(s)