Between centers boring bar

Hello There, Guest! Register

Thread Modes

Between centers boring bar

chucketn Offline

Offline

Junior

Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN

#3

11-06-2014, 09:48 AM

(11-06-2014, 09:38 AM)JScott Wrote: My guess is to start at the beginning. Is your tailstock aligned with the headstock?

That is where I'll start.

Chuck

Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Between centers boring bar - by chucketn - 11-06-2014, 09:23 AM

RE: Between centers boring bar - by JScott - 11-06-2014, 09:38 AM

RE: Between centers boring bar - by chucketn - 11-06-2014, 09:48 AM

RE: Between centers boring bar - by f350ca - 11-06-2014, 09:59 AM

RE: Between centers boring bar - by chucketn - 11-06-2014, 10:09 AM

RE: Between centers boring bar - by f350ca - 11-06-2014, 10:27 AM

RE: Between centers boring bar - by Lordedmond - 11-06-2014, 10:31 AM

RE: Between centers boring bar - by dallen - 11-06-2014, 10:34 AM

RE: Between centers boring bar - by EdK - 11-06-2014, 11:04 AM

RE: Between centers boring bar - by chucketn - 11-06-2014, 11:54 AM

RE: Between centers boring bar - by TomG - 11-06-2014, 12:51 PM

RE: Between centers boring bar - by chucketn - 11-06-2014, 01:10 PM

RE: Between centers boring bar - by TomG - 11-06-2014, 02:44 PM

RE: Between centers boring bar - by doubleboost - 11-06-2014, 01:07 PM

RE: Between centers boring bar - by Lordedmond - 11-06-2014, 01:21 PM

RE: Between centers boring bar - by Dr Stan - 11-06-2014, 10:19 PM

RE: Between centers boring bar - by chucketn - 11-07-2014, 06:49 AM

RE: Between centers boring bar - by stevec - 11-07-2014, 07:33 AM

RE: Between centers boring bar - by Dr Stan - 11-07-2014, 12:42 PM

RE: Between centers boring bar - by doubleboost - 11-07-2014, 12:45 PM

RE: Between centers boring bar - by chucketn - 11-07-2014, 05:19 PM

RE: Between centers boring bar - by Hopefuldave - 11-09-2014, 08:17 AM

Users browsing this thread: 1 Guest(s)