Setting stroke on Douglas Shaper

Thread Modes

Setting stroke on Douglas Shaper

Shawn

Junior

Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada

09-20-2014, 01:05 AM

Ok here's another question. Looking at the photo of the scotch yoke on Mayhems shaper and the one on mine there is a significant difference in the length of the dovetail that is attached to the large gear. I don't understand the point of having it longer than half the diameter of the gear?

I'll stop with the questions for tonight : )

Shawn

Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Setting stroke on Douglas Shaper - by Shawn - 09-19-2014, 03:23 PM

RE: Setting stroke on Douglas Shaper - by dallen - 09-19-2014, 03:28 PM

RE: Setting stroke on Douglas Shaper - by Shawn - 09-19-2014, 04:35 PM

RE: Setting stroke on Douglas Shaper - by f350ca - 09-19-2014, 04:42 PM

RE: Setting stroke on Douglas Shaper - by dallen - 09-19-2014, 06:57 PM

RE: Setting stroke on Douglas Shaper - by Mayhem - 09-19-2014, 11:30 PM

RE: Setting stroke on Douglas Shaper - by Shawn - 09-20-2014, 01:00 AM

RE: Setting stroke on Douglas Shaper - by Shawn - 09-20-2014, 01:05 AM