04-16-2014, 05:42 PM
I'm working on a power feed for the X axis on my mill. I have to make an adapter that fits onto the lead screw shaft and gets pinned to it. The power feed is made for a Bridgeport mill but my mill has a 17mm lead screw size so the adapter connects my lead screw to the power feed which is dimensioned for a 5/8" shaft.
My question is what's the best way to turn this so the OD is concentric with the ID of the bore for the lead screw? I'll be drilling close to the 17mm size and then using a 17mm reamer for the ID.
Ed
My question is what's the best way to turn this so the OD is concentric with the ID of the bore for the lead screw? I'll be drilling close to the 17mm size and then using a 17mm reamer for the ID.
Ed