The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
1-2-3 blocks

Thread Modes
1-2-3 blocks
hswaters Offline
Freshman
**
Posts: 37
Threads: 8
Joined: Jan 2014
Location: Houston Texas USA
#1
01-31-2014, 05:45 PM (This post was last modified: 01-31-2014, 05:46 PM by hswaters.)
I would like to know what is the purpose of the holes in 1-2-3 blocks? I am sure they didn't drill them in just because the like the way it looks. Confused
Ben Franklin;
"Those who would give up essential liberty to purchase a little temporary safety deserve neither liberty nor safety


Reply
Thanks given by:


Messages In This Thread
1-2-3 blocks - by hswaters - 01-31-2014, 05:45 PM
RE: 1-2-3 blocks - by aametalmaster - 01-31-2014, 05:53 PM
RE: 1-2-3 blocks - by TomG - 01-31-2014, 07:10 PM
RE: 1-2-3 blocks - by krv3000 - 01-31-2014, 08:08 PM
RE: 1-2-3 blocks - by hswaters - 01-31-2014, 08:18 PM
RE: 1-2-3 blocks - by arvidj - 01-31-2014, 10:09 PM
RE: 1-2-3 blocks - by hswaters - 01-31-2014, 10:28 PM
RE: 1-2-3 blocks - by stevec - 02-01-2014, 07:40 AM
RE: 1-2-3 blocks - by Arbalest - 02-01-2014, 08:14 AM
RE: 1-2-3 blocks - by chucketn - 02-01-2014, 08:19 AM
RE: 1-2-3 blocks - by EdK - 02-01-2014, 07:01 PM
RE: 1-2-3 blocks - by PixMan - 02-01-2014, 07:30 PM
RE: 1-2-3 blocks - by EdK - 02-01-2014, 07:37 PM
RE: 1-2-3 blocks - by arvidj - 02-02-2014, 09:11 AM
RE: 1-2-3 blocks - by Mayhem - 02-01-2014, 11:38 PM
RE: 1-2-3 blocks - by arvidj - 02-02-2014, 09:22 AM
RE: 1-2-3 blocks - by aametalmaster - 02-02-2014, 10:16 AM
RE: 1-2-3 blocks - by TomG - 02-02-2014, 10:52 AM



Users browsing this thread: 1 Guest(s)