MetalworkingFun Forum › Machining › General Metalworking Discussion v
Some of my wrought iron.

Thread Modes
Some of my wrought iron.
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#14
04-01-2012, 06:35 PM
Here is my powered scroller. 60:1 gearbox and a 3/4 hp motor 1,000 inch lbs of torque I use the same setup to power my slip roll as well as my train track roller and my small ring former...Bob


Attached Files Thumbnail(s)
           

.jpg   scmotor.jpg (Size: 20.19 KB / Downloads: 41)
.jpg   motorgearbox.jpg (Size: 22.35 KB / Downloads: 41)
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Some of my wrought iron. - by aametalmaster - 03-27-2012, 07:47 PM
RE: Some of my wrought iron. - by aametalmaster - 03-27-2012, 08:01 PM
RE: Some of my wrought iron. - by EdK - 03-28-2012, 06:41 AM
RE: Some of my wrought iron. - by PixMan - 03-28-2012, 11:16 AM
RE: Some of my wrought iron. - by ETC57 - 03-28-2012, 12:36 PM
RE: Some of my wrought iron. - by DaveH - 03-28-2012, 02:43 PM
RE: Some of my wrought iron. - by doubleboost - 03-28-2012, 02:59 PM
RE: Some of my wrought iron. - by aametalmaster - 03-28-2012, 04:39 PM
RE: Some of my wrought iron. - by DaveH - 04-01-2012, 02:15 PM
RE: Some of my wrought iron. - by aametalmaster - 04-01-2012, 02:27 PM
RE: Some of my wrought iron. - by DaveH - 04-01-2012, 02:31 PM
RE: Some of my wrought iron. - by RobWilson - 04-01-2012, 05:08 PM
RE: Some of my wrought iron. - by aametalmaster - 04-01-2012, 06:31 PM
RE: Some of my wrought iron. - by aametalmaster - 04-01-2012, 06:35 PM
RE: Some of my wrought iron. - by aametalmaster - 04-01-2012, 06:41 PM
RE: Some of my wrought iron. - by aametalmaster - 04-01-2012, 06:45 PM
RE: Some of my wrought iron. - by RobWilson - 04-04-2012, 10:50 AM
RE: Some of my wrought iron. - by aametalmaster - 04-04-2012, 04:20 PM
RE: Some of my wrought iron. - by Highpower - 04-04-2012, 09:23 PM
RE: Some of my wrought iron. - by aametalmaster - 04-05-2012, 03:46 AM
RE: Some of my wrought iron. - by Highpower - 04-05-2012, 07:09 AM



Users browsing this thread: 1 Guest(s)