Anyone here capable of gear cutting?
#11
Make a roll of Plasticine, flatten it on the bench, roll your gear along it to form a rack in the Plasticine, Cut along the centre of your rack to give a sharp edge, and measure the inclination of the teeth with a protractor. You may need to chill the Plasticine in the 'fridge before you slice it to avoid 'pulling'

Andrew
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
Anyone here capable of gear cutting? - by PixMan - 12-19-2013, 12:27 AM
RE: Anyone here capable of gear cutting? - by EdK - 12-19-2013, 07:34 AM
RE: Anyone here capable of gear cutting? - by EdK - 12-19-2013, 01:20 PM
RE: Anyone here capable of gear cutting? - by awemawson - 12-20-2013, 03:58 AM



Users browsing this thread: 1 Guest(s)