05-07-2013, 08:11 AM
The thing I like about your gauge Steve, is that you don't need to be able to see the markings on the scale. Just keep sliding it in until the drill tip fits in with no gap on either side. 
Willie
|
Hole Sizes for Reaming
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Hole Sizes for Reaming - by EdK - 05-05-2013, 02:12 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 02:59 PM
RE: Hole Sizes for Reaming - by EdK - 05-05-2013, 03:10 PM
RE: Hole Sizes for Reaming - by doubleboost - 05-05-2013, 03:12 PM
RE: Hole Sizes for Reaming - by wrustle - 05-05-2013, 03:28 PM
RE: Hole Sizes for Reaming - by f350ca - 05-05-2013, 07:09 PM
RE: Hole Sizes for Reaming - by EdK - 05-06-2013, 05:52 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 08:29 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 10:54 AM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 11:11 AM
RE: Hole Sizes for Reaming - by Highpower - 05-06-2013, 12:48 PM
RE: Hole Sizes for Reaming - by stevec - 05-06-2013, 03:29 PM
RE: Hole Sizes for Reaming - by f350ca - 05-06-2013, 06:35 PM
RE: Hole Sizes for Reaming - by stevec - 05-07-2013, 05:51 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:11 AM
RE: Hole Sizes for Reaming - by Mayhem - 05-07-2013, 09:46 AM
RE: Hole Sizes for Reaming - by Highpower - 05-07-2013, 08:00 PM
RE: Hole Sizes for Reaming - by Mayhem - 05-08-2013, 08:05 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:55 AM
RE: Hole Sizes for Reaming - by f350ca - 05-08-2013, 11:49 AM
RE: Hole Sizes for Reaming - by Highpower - 05-08-2013, 08:59 PM
|
Users browsing this thread: