MetalworkingFun Forum › Machinery › Lathes v
1945 Craftsman Info needed

Thread Modes
1945 Craftsman Info needed
bobm4360 Offline
Freshman
**
Posts: 32
Threads: 2
Joined: Jul 2012
Location: Oak Harbor, WA
#10
08-29-2012, 11:53 PM
The 10" and 12" spindles have the same part number for the Timken-equipped lathes. Specs say 25/32" spindle bore.
Regards,
Bob
bobm4360, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by: Highpower , SnailPowered


Messages In This Thread
1945 Craftsman Info needed - by SnailPowered - 08-28-2012, 06:27 PM
RE: 1945 Craftsman Info needed - by EdK - 08-28-2012, 06:56 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-28-2012, 10:13 PM
RE: 1945 Craftsman Info needed - by Mayhem - 08-29-2012, 08:26 AM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-29-2012, 08:28 AM
RE: 1945 Craftsman Info needed - by stevec - 08-29-2012, 04:01 PM
RE: 1945 Craftsman Info needed - by EdK - 08-29-2012, 05:14 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-29-2012, 06:51 PM
RE: 1945 Craftsman Info needed - by bobm4360 - 08-29-2012, 11:53 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-30-2012, 03:47 AM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-01-2012, 03:43 PM
RE: 1945 Craftsman Info needed - by EdK - 09-01-2012, 08:05 PM
RE: 1945 Craftsman Info needed - by Highpower - 09-02-2012, 10:35 AM
RE: 1945 Craftsman Info needed - by Mayhem - 09-01-2012, 09:38 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-02-2012, 10:39 AM
RE: 1945 Craftsman Info needed - by ETC57 - 09-02-2012, 06:22 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-27-2012, 01:26 PM
RE: 1945 Craftsman Info needed - by bobm4360 - 09-28-2012, 12:55 AM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-28-2012, 01:09 AM



Users browsing this thread: 4 Guest(s)