MetalworkingFun Forum › Machinery › Lathes v
1945 Craftsman Info needed

Thread Modes
1945 Craftsman Info needed
SnailPowered Offline
Junior
****
Posts: 258
Threads: 13
Joined: Aug 2012
Location: USA
#9
08-29-2012, 06:51 PM
I'm thinking you guys are probably right. I will hold out hope that it is bigger but my guess is that it is the same 3/4" as the 10" so that you can use MT #3 collets in it. Chin
SnailPowered, proud to be a member of MetalworkingFun since Aug 2012.
Reply
Thanks given by:


Messages In This Thread
1945 Craftsman Info needed - by SnailPowered - 08-28-2012, 06:27 PM
RE: 1945 Craftsman Info needed - by EdK - 08-28-2012, 06:56 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-28-2012, 10:13 PM
RE: 1945 Craftsman Info needed - by Mayhem - 08-29-2012, 08:26 AM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-29-2012, 08:28 AM
RE: 1945 Craftsman Info needed - by stevec - 08-29-2012, 04:01 PM
RE: 1945 Craftsman Info needed - by EdK - 08-29-2012, 05:14 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-29-2012, 06:51 PM
RE: 1945 Craftsman Info needed - by bobm4360 - 08-29-2012, 11:53 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 08-30-2012, 03:47 AM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-01-2012, 03:43 PM
RE: 1945 Craftsman Info needed - by EdK - 09-01-2012, 08:05 PM
RE: 1945 Craftsman Info needed - by Highpower - 09-02-2012, 10:35 AM
RE: 1945 Craftsman Info needed - by Mayhem - 09-01-2012, 09:38 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-02-2012, 10:39 AM
RE: 1945 Craftsman Info needed - by ETC57 - 09-02-2012, 06:22 PM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-27-2012, 01:26 PM
RE: 1945 Craftsman Info needed - by bobm4360 - 09-28-2012, 12:55 AM
RE: 1945 Craftsman Info needed - by SnailPowered - 09-28-2012, 01:09 AM



Users browsing this thread: 7 Guest(s)