|
Spindle Tach
|
08-28-2012, 12:35 PM
(08-28-2012, 11:49 AM)EdK Wrote: The dedicated ones also give you RPMs and SFM at the touch of a switch. YMMV True THAT!  One thing I will say about both types, is that I can set the speed on my lathe at any RPM and both tachs AGREE with each other! 225 RPM 371 RPM 928 RPM 1153 RPM.... It doesn't matter. They are always exactly the same. Pretty impressive in my mind for some rather "inexpensive" electronics. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spindle Tach - by Bustednuklz - 08-11-2012, 06:41 PM
RE: Spindle Tach - by dallen - 08-11-2012, 07:48 PM
RE: Spindle Tach - by stevec - 08-11-2012, 08:43 PM
RE: Spindle Tach - by EdK - 08-11-2012, 08:46 PM
RE: Spindle Tach - by ScrapMetal - 08-11-2012, 10:55 PM
RE: Spindle Tach - by Highpower - 08-12-2012, 01:21 AM
RE: Spindle Tach - by EdK - 08-12-2012, 09:16 AM
RE: Spindle Tach - by Highpower - 08-11-2012, 09:54 PM
RE: Spindle Tach - by truckin23 - 08-11-2012, 11:16 PM
RE: Spindle Tach - by TOM REED - 08-12-2012, 03:15 AM
RE: Spindle Tach - by Rickabilly - 08-27-2012, 03:09 PM
RE: Spindle Tach - by TOM REED - 08-28-2012, 03:02 AM
RE: Spindle Tach - by Rickabilly - 08-28-2012, 04:03 AM
RE: Spindle Tach - by Highpower - 08-28-2012, 10:33 AM
RE: Spindle Tach - by EdK - 08-28-2012, 11:49 AM
RE: Spindle Tach - by Highpower - 08-28-2012, 12:35 PM
RE: Spindle Tach - by TOM REED - 08-29-2012, 10:11 PM
RE: Spindle Tach - by EdK - 08-30-2012, 06:01 AM
RE: Spindle Tach - by Rickabilly - 08-30-2012, 03:51 AM
RE: Spindle Tach - by Highpower - 08-30-2012, 09:35 AM
RE: Spindle Tach - by TOM REED - 08-30-2012, 10:36 AM
RE: Spindle Tach - by henryarnold - 10-23-2012, 10:21 PM
RE: Spindle Tach - by Highpower - 08-30-2012, 02:08 PM
RE: Spindle Tach - by EdK - 08-30-2012, 03:46 PM
|
