MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Parallels - what are the differences?

Thread Modes
Parallels - what are the differences?
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#12
08-26-2012, 10:32 AM
(08-26-2012, 10:01 AM)Mayhem Wrote: Ed, I think Bob positions them flat on the vise bed.

OK, so you would need a number of different diameters of bearing races to use depending on the width of your work piece. I think I get it now.

Ed
Reply
Thanks given by:


Messages In This Thread
Parallels - what are the differences? - by Mayhem - 04-22-2012, 03:29 AM
RE: Parallels - what are the differences? - by Bogstandard - 04-22-2012, 12:36 PM
RE: Parallels - what are the differences? - by EdK - 08-26-2012, 10:32 AM



Users browsing this thread: 4 Guest(s)