|
How do I do this?
|
08-25-2012, 10:51 PM
You would have to make a slightly oversize "male" version of the shape out of a good tool steel, heat treat it, then grind it to a final size. Given the tough stainless steel (I'd go with 316), I'd suggest a half-shape broach. You could then mount it in the spindle of your mill, lock the spindle and incrementally feed out until the half shape is complete. Then rotate the broach 180º and finish the opposite side of the shape.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How do I do this? - by Wongster - 08-20-2012, 08:56 AM
RE: How do I do this? - by Bill Gruby - 08-20-2012, 12:37 PM
RE: How do I do this? - by TomG - 08-20-2012, 12:49 PM
RE: How do I do this? - by Bill Gruby - 08-20-2012, 03:11 PM
RE: How do I do this? - by Wongster - 08-20-2012, 05:29 PM
RE: How do I do this? - by claudef - 08-20-2012, 06:56 PM
RE: How do I do this? - by PixMan - 08-20-2012, 06:55 PM
RE: How do I do this? - by Mayhem - 08-21-2012, 07:23 AM
RE: How do I do this? - by Wongster - 08-22-2012, 06:05 PM
RE: How do I do this? - by PixMan - 08-25-2012, 10:51 PM
RE: How do I do this? - by dallen - 08-26-2012, 08:15 AM
RE: How do I do this? - by Mayhem - 08-26-2012, 08:17 AM
RE: How do I do this? - by PixMan - 08-26-2012, 08:35 AM
RE: How do I do this? - by stevec - 08-26-2012, 09:06 AM
RE: How do I do this? - by Wongster - 08-26-2012, 11:21 AM
|
