08-23-2012, 08:45 PM
(This post was last modified: 08-23-2012, 08:51 PM by NevadaBlue.)
Here's my big saw. In this pic it is tied down, I was in the middle of moving stuff in the shop. It is an 'Elite Mfg' saw. I haven't been able to find ANYTHING about it online, but it works. It is running a 1" band now, should be 3/4". I think it is 8x13 or something...
I use a HF red saw for my vertical saw, I put a little table made of 1/4" plate on it and use it a lot. Works great, I sit on the end of the stand. Perfect... this pic is just after it arrived. I clamped a plate on the existing vertical table and put a stack of shop towels on the end of the stand for my butt.
I use a HF red saw for my vertical saw, I put a little table made of 1/4" plate on it and use it a lot. Works great, I sit on the end of the stand. Perfect... this pic is just after it arrived. I clamped a plate on the existing vertical table and put a stack of shop towels on the end of the stand for my butt.
Ken
An old tired/retired/wanna-be machinist.
An old tired/retired/wanna-be machinist.