|
How do I do this?
|
08-20-2012, 05:29 PM
Thanks guys. I'll try using the rotary table and a small endmill to see if I can pull this off. Only 3 pieces needed this round.
Regards, Wong
Wongster
http://www.wongstersproduction.com Proud to be a member of MetalworkingFun Forum since Mar 2012. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How do I do this? - by Wongster - 08-20-2012, 08:56 AM
RE: How do I do this? - by Bill Gruby - 08-20-2012, 12:37 PM
RE: How do I do this? - by TomG - 08-20-2012, 12:49 PM
RE: How do I do this? - by Bill Gruby - 08-20-2012, 03:11 PM
RE: How do I do this? - by Wongster - 08-20-2012, 05:29 PM
RE: How do I do this? - by claudef - 08-20-2012, 06:56 PM
RE: How do I do this? - by PixMan - 08-20-2012, 06:55 PM
RE: How do I do this? - by Mayhem - 08-21-2012, 07:23 AM
RE: How do I do this? - by Wongster - 08-22-2012, 06:05 PM
RE: How do I do this? - by PixMan - 08-25-2012, 10:51 PM
RE: How do I do this? - by dallen - 08-26-2012, 08:15 AM
RE: How do I do this? - by Mayhem - 08-26-2012, 08:17 AM
RE: How do I do this? - by PixMan - 08-26-2012, 08:35 AM
RE: How do I do this? - by stevec - 08-26-2012, 09:06 AM
RE: How do I do this? - by Wongster - 08-26-2012, 11:21 AM
|
