08-17-2012, 09:22 PM
Question for the metallurgists in the house. 
Is it possible to machine, drill, tap with HSS?
(Rockwell C28-C32)
Is it possible to machine, drill, tap with HSS?
(Rockwell C28-C32)
Willie
|
4142 Pre-hard?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
4142 Pre-hard? - by Highpower - 08-17-2012, 09:22 PM
RE: 4142 Pre-hard? - by TomG - 08-17-2012, 09:53 PM
RE: 4142 Pre-hard? - by Highpower - 08-17-2012, 10:40 PM
RE: 4142 Pre-hard? - by TomG - 08-17-2012, 10:55 PM
RE: 4142 Pre-hard? - by Highpower - 08-18-2012, 12:30 AM
RE: 4142 Pre-hard? - by PixMan - 08-18-2012, 05:59 AM
RE: 4142 Pre-hard? - by Highpower - 08-18-2012, 08:49 AM
RE: 4142 Pre-hard? - by Sunset Machine - 08-18-2012, 09:04 AM
RE: 4142 Pre-hard? - by Highpower - 08-18-2012, 09:19 AM
RE: 4142 Pre-hard? - by DaveH - 08-18-2012, 11:09 AM
RE: 4142 Pre-hard? - by Sunset Machine - 08-18-2012, 12:47 PM
RE: 4142 Pre-hard? - by stevec - 08-18-2012, 02:46 PM
RE: 4142 Pre-hard? - by Highpower - 08-18-2012, 08:35 PM
|
Users browsing this thread: 2 Guest(s)