|
Wire clamp tool...
|
 (08-10-2012, 05:44 PM)ETC57 Wrote: ...I must ask just what it's for?... It is for forming wire clamps - the link posted by Highpower shows it being used: (08-10-2012, 06:12 AM)Highpower Wrote: Perhaps here: http://bbs.homeshopmachinist.net/threads...take-on-it
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Wire clamp tool... - by Nitsuj - 08-09-2012, 10:00 PM
RE: Wire clamp tool... - by TOM REED - 08-10-2012, 01:05 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 07:36 AM
RE: Wire clamp tool... - by Highpower - 08-10-2012, 06:12 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 07:42 AM
RE: Wire clamp tool... - by DaveH - 08-10-2012, 08:27 AM
RE: Wire clamp tool... - by TOM REED - 08-10-2012, 08:48 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:38 PM
RE: Wire clamp tool... - by f350ca - 08-10-2012, 09:45 AM
RE: Wire clamp tool... - by ETC57 - 08-10-2012, 05:44 PM
RE: Wire clamp tool... - by stevec - 08-10-2012, 06:42 PM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:41 PM
RE: Wire clamp tool... - by Mayhem - 08-10-2012, 08:11 PM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:51 PM
RE: Wire clamp tool... - by claudef - 08-14-2012, 06:47 PM
RE: Wire clamp tool... - by Highpower - 08-15-2012, 07:17 AM
RE: Wire clamp tool... - by claudef - 08-16-2012, 07:09 AM
RE: Wire clamp tool... - by Highpower - 08-16-2012, 09:36 AM
RE: Wire clamp tool... - by Mayhem - 08-10-2012, 08:36 PM
RE: Wire clamp tool... - by sasquatch - 08-14-2012, 07:26 PM
RE: Wire clamp tool... - by f350ca - 08-14-2012, 09:05 PM
RE: Wire clamp tool... - by mikecwik - 08-14-2012, 09:44 PM
RE: Wire clamp tool... - by DaveH - 08-16-2012, 11:56 AM
|
