MetalworkingFun Forum › Machining › General Metalworking Discussion v
Wire clamp tool...

Thread Modes
Wire clamp tool...
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#8
08-10-2012, 09:45 AM
There was another post recently on one of the other forums but can't recall which one. They're a neat little tool, was given one at Christmas. To be honest haven't needed it yet but its in the arsenal.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Wire clamp tool... - by Nitsuj - 08-09-2012, 10:00 PM
RE: Wire clamp tool... - by TOM REED - 08-10-2012, 01:05 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 07:36 AM
RE: Wire clamp tool... - by Highpower - 08-10-2012, 06:12 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 07:42 AM
RE: Wire clamp tool... - by DaveH - 08-10-2012, 08:27 AM
RE: Wire clamp tool... - by TOM REED - 08-10-2012, 08:48 AM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:38 PM
RE: Wire clamp tool... - by f350ca - 08-10-2012, 09:45 AM
RE: Wire clamp tool... - by ETC57 - 08-10-2012, 05:44 PM
RE: Wire clamp tool... - by stevec - 08-10-2012, 06:42 PM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:41 PM
RE: Wire clamp tool... - by Mayhem - 08-10-2012, 08:11 PM
RE: Wire clamp tool... - by Nitsuj - 08-10-2012, 08:51 PM
RE: Wire clamp tool... - by claudef - 08-14-2012, 06:47 PM
RE: Wire clamp tool... - by Highpower - 08-15-2012, 07:17 AM
RE: Wire clamp tool... - by claudef - 08-16-2012, 07:09 AM
RE: Wire clamp tool... - by Highpower - 08-16-2012, 09:36 AM
RE: Wire clamp tool... - by Mayhem - 08-10-2012, 08:36 PM
RE: Wire clamp tool... - by sasquatch - 08-14-2012, 07:26 PM
RE: Wire clamp tool... - by f350ca - 08-14-2012, 09:05 PM
RE: Wire clamp tool... - by mikecwik - 08-14-2012, 09:44 PM
RE: Wire clamp tool... - by DaveH - 08-16-2012, 11:56 AM



Users browsing this thread: 5 Guest(s)