Tinker cutter grinder?

Hello There, Guest! Register

Thread Modes

Tinker cutter grinder?

NevadaBlue Offline

Offline

Sophmore

Posts: 50
Threads: 4
Joined: Jul 2012
Location: Nevada

#17

08-08-2012, 11:05 PM

I guess my thoughts were that the precise ground shaft would align the two bushings accurately enough when used with the loctite and that wouldn't require such an accurate boring job (I've never bored anything on the mill yet) or honing either. That was my hope anyway...

Ken
An old tired/retired/wanna-be machinist. Cool

Cool

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Tinker cutter grinder? - by NevadaBlue - 07-28-2012, 10:07 PM

RE: Tinker cutter grinder? - by Highpower - 07-29-2012, 12:20 AM

RE: Tinker cutter grinder? - by EdK - 07-29-2012, 08:45 AM

RE: Tinker cutter grinder? - by NevadaBlue - 07-29-2012, 12:46 PM

RE: Tinker cutter grinder? - by DaveH - 07-29-2012, 12:50 PM

RE: Tinker cutter grinder? - by NevadaBlue - 07-29-2012, 08:57 PM

RE: Tinker cutter grinder? - by NevadaBlue - 08-05-2012, 11:52 AM

RE: Tinker cutter grinder? - by Sunset Machine - 08-06-2012, 09:23 AM

RE: Tinker cutter grinder? - by DaveH - 08-05-2012, 12:08 PM

RE: Tinker cutter grinder? - by doubleboost - 08-05-2012, 02:55 PM

RE: Tinker cutter grinder? - by EdK - 08-05-2012, 05:43 PM

RE: Tinker cutter grinder? - by dallen - 08-06-2012, 10:09 AM

RE: Tinker cutter grinder? - by stevec - 08-06-2012, 10:21 AM

RE: Tinker cutter grinder? - by DaveH - 08-06-2012, 05:12 PM

RE: Tinker cutter grinder? - by Sunset Machine - 08-08-2012, 12:12 PM

RE: Tinker cutter grinder? - by DaveH - 08-08-2012, 02:57 PM

RE: Tinker cutter grinder? - by NevadaBlue - 08-08-2012, 11:05 PM

RE: Tinker cutter grinder? - by Highpower - 08-09-2012, 12:24 AM

RE: Tinker cutter grinder? - by stevec - 08-09-2012, 05:32 AM

RE: Tinker cutter grinder? - by NevadaBlue - 08-12-2012, 10:33 PM

Users browsing this thread: 8 Guest(s)