MetalworkingFun Forum › Machinery › Milling Machines v
Clausing 8520 Restoration

Thread Modes
Clausing 8520 Restoration
truckin23
Unregistered
 
#17
08-05-2012, 11:54 AM
Hi Andrew ,

If you could I'd like to get the measurements of your mills footprint
to see if I could fit one in a space I have . Mainly I need width of cabinet and
depth from back of motor to front of cabinet .

Thanks Bob
Reply
Thanks given by:


Messages In This Thread
Clausing 8520 Restoration - by lazylathe - 07-22-2012, 12:55 PM
RE: Clausing 8520 Restoration - by dallen - 07-22-2012, 01:58 PM
RE: Clausing 8520 Restoration - by krv3000 - 07-22-2012, 04:06 PM
RE: Clausing 8520 Restoration - by Mayhem - 07-23-2012, 05:57 AM
RE: Clausing 8520 Restoration - by Bill Gruby - 07-23-2012, 02:30 PM
RE: Clausing 8520 Restoration - by lazylathe - 07-23-2012, 03:12 PM
RE: Clausing 8520 Restoration - by lazylathe - 07-24-2012, 05:47 AM
RE: Clausing 8520 Restoration - by lazylathe - 07-24-2012, 05:48 AM
RE: Clausing 8520 Restoration - by lazylathe - 07-24-2012, 05:51 AM
RE: Clausing 8520 Restoration - by DaveH - 07-24-2012, 06:02 AM
RE: Clausing 8520 Restoration - by EdK - 07-24-2012, 06:06 AM
RE: Clausing 8520 Restoration - by Mayhem - 07-24-2012, 07:49 AM
RE: Clausing 8520 Restoration - by truckin23 - 07-24-2012, 11:51 PM
RE: Clausing 8520 Restoration - by Bill Gruby - 07-25-2012, 03:54 AM
RE: Clausing 8520 Restoration - by lazylathe - 07-25-2012, 07:02 AM
RE: Clausing 8520 Restoration - by petertha - 11-02-2012, 09:58 PM
RE: Clausing 8520 Restoration - by sasquatch - 07-25-2012, 07:43 AM
RE: Clausing 8520 Restoration - by truckin23 - 08-05-2012, 11:54 AM
RE: Clausing 8520 Restoration - by doubleboost - 08-05-2012, 12:07 PM



Users browsing this thread: 1 Guest(s)