MetalworkingFun Forum › Machining › How-To's v
Rakes?

Thread Modes
Rakes?
Tony Wells Offline
Sophmore
***
Posts: 200
Threads: 4
Joined: Feb 2012
Location: Tyler, TX USA
#5
07-31-2012, 06:28 PM
No, that is the side clearance. The rake is the angle on the top of the tool, starting at the cutting edge itself, and either pointing or inclined up, above the axis of the spindle (negative) or pointing or inclined downward, below the axis (positive).
Reply
Thanks given by:


Messages In This Thread
Rakes? - by ETC57 - 07-31-2012, 09:53 AM
RE: Rakes? - by EdK - 07-31-2012, 10:18 AM
RE: Rakes? - by Highpower - 07-31-2012, 10:27 AM
RE: Rakes? - by ETC57 - 07-31-2012, 06:20 PM
RE: Rakes? - by Tony Wells - 07-31-2012, 06:28 PM
RE: Rakes? - by DaveH - 07-31-2012, 06:41 PM
RE: Rakes? - by ETC57 - 07-31-2012, 06:36 PM
RE: Rakes? - by Tony Wells - 07-31-2012, 07:24 PM
RE: Rakes? - by TomG - 07-31-2012, 08:50 PM
RE: Rakes? - by Mayhem - 08-01-2012, 04:24 AM
RE: Rakes? - by stevec - 08-01-2012, 07:25 AM
RE: Rakes? - by TomG - 08-01-2012, 07:53 AM
RE: Rakes? - by ETC57 - 08-01-2012, 10:21 AM
RE: Rakes? - by Mayhem - 08-01-2012, 07:41 AM
RE: Rakes? - by ETC57 - 08-01-2012, 04:54 PM
RE: Rakes? - by stevec - 08-01-2012, 07:45 PM
RE: Rakes? - by Mayhem - 08-01-2012, 08:31 PM
RE: Rakes? - by PixMan - 09-01-2012, 01:04 PM
RE: Rakes? - by stevec - 09-01-2012, 01:14 PM
RE: Rakes? - by DaveH - 09-01-2012, 01:36 PM



Users browsing this thread: 5 Guest(s)