Ok Willie,
so your talking about the angle of the cutting edge of the tool from top to bottom right?
Example: a raw blank 1/2" hss tool is 90 deg vertical to the top and bottom if you change that to 20 deg ether pos or neg that is rake
yes?
Thanks Ed for the sites!
Jerry.
so your talking about the angle of the cutting edge of the tool from top to bottom right?
Example: a raw blank 1/2" hss tool is 90 deg vertical to the top and bottom if you change that to 20 deg ether pos or neg that is rake
yes?
Thanks Ed for the sites!
Jerry.
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.